Lesson 3

Add the back and cut the joints

Put a 1/4" back on the cabinet and let Dry Fit turn every overlap into a dado or rabbet.

You need: The cabinet from Lesson 2.

What you'll build

The first base cabinet in 3D with its quarter inch Back in place behind the shelves, tagged Side, Shelf and Back
The first cabinet with its back on and the dados and rabbets cut in both sides. The Overall in the status bar is bigger: it also counts the parts still lying out front.

Overall size 18" W × 23-1/4" D × 29-1/4" H

Parts key

NameSizeWhat it isFrom
Side29-1/4" × 23-1/4" ×2The cabinet's sides, placed in Lesson 2. Each gets 3 rabbets and a dado here.Sheet A
Shelf17" × 23" ×3Bottom, middle and top shelf, placed in Lesson 2Sheet B
Back17-1/4" × 29-1/4" ×1The cabinet's 1/4" back. You cut two; this lesson uses the first.Sheet D

After this lesson you can let Dry Fit turn overlapping parts into dados and rabbets, and read each joint's size.

  1. In In the shop, click the first Back row (17-1/4" × 29-1/4") under Sheet D. The Wall back row above it is for Lesson 5. Click On edge so it stands up 29-1/4" tall, facing the room.
  2. Under Position, type Left edge 3/8, Off floor 0, Back edge 0, pressing Return after each. That stands it against the Back wall line behind the cabinet and centers it: the back is 17-1/4" wide and the cabinet 18", so it reaches 3/8" into each Side.
View from behind the cabinet showing the quarter inch Back in place, selected, with name tags on the Back and both Sides
Seen from behind (drag empty floor to turn the view): the Back covers the cabinet, flush with the Sides' back edges.
  1. Click the first Side row under Sheet A, the left Side at Left edge 0. Move the pointer over Cut joints where parts overlap in the right panel to preview the cuts in red, then click it. A message reads Cut 3 rabbets and a dado in Side.
Red preview on the left Side showing two rabbets at the ends, a dado in the middle and a rabbet along the back edge
Before the click: the preview shows a rabbet at the top and bottom, a dado for the middle shelf, and a rabbet down the back edge for the back panel.
The left Side on its own showing the cut joints, with the joint list in the right panel
After the click: the Side with its joints cut (other parts hidden here so you can see them). The list gives each joint's size and position. The dado and end rabbets run through into the back rabbet, the way you'd cut them on the table saw.
  1. Click the second Side row, the right Side at Left edge 17-1/4", and click Cut joints where parts overlap again. It gets the same 3 rabbets and a dado, on the opposite face.

Both Sides now hold the three Shelves and the Back. Check drops from 16 to 11; the rest are the parts still lying out front.